×
According to the monkey car lining manufacturer, the monkey car lining, officially known as the mine ropeway, is mainly used in underground mines. The wire rope is installed on the driving wheel, supporting wheel, pressure wheel, and detour wheel and is tightened by the tensioning device. , the output power of the driving device drives the driving wheel and the wire rope to operate, thereby realizing the principle of transporting miners. The underground mining overhead ropeway is used to transport miners. The purpose is to shorten the journey time for miners to go up and down the well, and reduce the physical energy consumption of the miners going up and down the well.
According to the monkey car lining manufacturer, the monkey car lining is mainly used to prevent direct contact between the crane and the steel rope. The lining plays a very important role in the service life of the steel rope. When the steel rope is running, it will rotate. If there is friction, If the coefficient is too high, it will hinder the rotation of the steel rope and damage the steel rope. In this case, the steel rope must be poured into the shaft with as little resistance as possible to reduce torque and rotational stress.
The Monkey Car Liner has an extremely low coefficient of friction and high wear resistance. On the one hand, it reduces the wear of the crown gear, and at the same time allows the steel rope to rotate freely, which is safer and extends the service life of the steel rope. So the Monkey Car Liner What are its characteristics? The monkey car lining manufacturer will introduce it to you!
(1) Good anti-permeability. The chemical properties of the lining are anti-permeability and resistance to various oils and corrosive liquids. At the same time, it has high safety, extremely low friction coefficient and extremely high wear resistance, which can be used on the crane. The pads release the rotation of the wire rope during operation to prevent the wire rope from wrapping around the friction wheel and causing the rope to slip.
(2) Long service life. Under the same industrial and mining conditions, it is 3-8 times that of other domestic materials. It has good machinability. The special hardness of the wheel pad facilitates the turning of the rope groove and extends its service life.
(3) Effectively extend the service life of the steel wire rope, the coefficient of friction is small, and its wear resistance is good, reducing damage to the steel rope and effectively extending the service life of the steel rope.
The driving wheel pad of the monkey cart is used on the driving wheel. The diameter of the driving wheel is 0.8 meters to 1.2 meters. The driving wheel pad bears the entire weight of the steel rope, the dead weight of the container, the cargo weight, the balance weight and various other operations during operation. Dynamic load and impact load, the pad is an annular body with a trapezoidal cross-section, which does not require splints and fasteners, making installation and maintenance quick, reducing the weight of the drive wheel, reducing the labor intensity during disassembly and assembly, and avoiding steel The rope directly rubs against the steel part of the driving wheel without generating sparks, effectively avoiding gas explosions. The friction lining installed on the driving wheel or friction wheel, referred to as a block, is used to increase the power of the driving wheel. A very important part of the load.
At the same time, the protection of the wire rope and the driving wheel is more reliable, which significantly increases the service life of the equipment and reduces the operating cost of the ropeway. It is suitable for use on aerial ropeways in mine shafts.
